Take a look at this typical drawing for all required input and please fill in your details below. We will get back to you shortly after submission with a tailor-made proposal to your requirements.

Your company: *

Contact name:

Phone: *

Email:

Description of Hot Runner System:

Material: select...ABSASACABFEPLCPPA 11PA 12PA 610PA 6PA 6.6PBTPPCPEPEEKPEIPESPETPPMMAPOMPPPPOPPSPSOtherPSUPVCSANSBTPU

Other material:

If you are using a different material than those listed above, please list here

Number of cavities:

Injected weight in grams for each nozzle:

Medium thickness in mm:

Colour change:

Yes

No

Injection type: select...DirectValve gateWith sprue onto runner

Shut off valve: select...with finished pinwithout finished pin

If your injection type is valve gate, please make your selection here

Number of nozzles:

Nozzle type: select...DDNF

To find out more about our range of nozzles, please click here >>

Injection Bushing: select...With filterWithout filter

Nozzle bushing: select...nonestandardstandard with coolingspecial

Connection set: select...5 pin6 pin10 pin16 pin24 pin

Temperature controller: select...1 zone2 zones3 zones4 zones5 zones6 zones7 zones8 zones9 zones10 zones11 zones12 zones13 zones14 zones15 zones16 zones17 zones18 zones19 zones20 zones21 zones22 zones23 zones24 zones

For more information on our UniCon temperature control systems, click here >>

Number of nozzles in x-direction:

x-direction spacing:

Number of nozzles in y-direction:

y-direction spacing:

Cable exit: select...Top of mouldBottom of mouldOperator sideOpposite operator

Upload your .dxf, .dwg or .igs or .zip file:

CAPTCHA

This question is for testing whether you are a human visitor and to prevent automated spam submissions.

What code is in the image?: *

Copy the characters (respecting upper/lower case) from the image.