displacement transducer
compliance testing
fluegas analysis
trace heating
electric heat tracing
technical services
Gefran 600 controller
testo 350
electrical heat tracing
parallel trace heating
emissons
testo thermal imager
heat tracing
Gefran indicators
maintenance
FAQs
series resistance cables
flue gas
Home Gefran 600 controller
Gefran 600 controller
Controller display doesn't switch on after being powered?
There is a possibility that the controller is faulty/blown. Kindly download a customer request form, complete and send to Thermon SA (Pty) Ltd. for a quote on repair.
The display of the temperature controller continuously flashes during start-up. What does this mean?
The display should only flash for the first few seconds after start-up. If it continues to flash the power supply is possibly faulty and must be repaired. Kindly download a customer request form, complete and send to Thermon SA (Pty) Ltd. for quote on repair.
How many solid state relays can I drive with a type D logic output from a temperature controller?
You may drive a maximum of 3 GTS gefran solid state relays - this may differ for other SSR brands.
Gefran controllers: LED 1 of the controller flashes on start-up. What does this mean?
This is a possible indication of an instrument that is in Soft-start mode - a function that serves to avoid thermal shock to a heating system. To check if controller is set for soft-start, follow these steps:
Gefran controller: Can the analog output on a 600-x-x-C-x-x be converted from 0-10V to 4-20mA?
Yes, although 0-10V is the standard output, the analogue signal can be changed to 4-20mA.
Gefran controller: Can the analog output on a 600-x-x-C-x-x be converted from 0-10V to 2-10V?
Yes, although 0-10V is the standard output, the analogue signal can be changed to 2-10V.
Gefran controller: I cannot access the hardware (Hrd) menu. Help!
- Press and hold the key until is displayed;
- Using the
- Add new comment
- Read more
Gefran controller: The top display is showing Err. What does this mean?
This usually an indication of a) a faulty Pt100 or analogue signal or b) wrong sensor type or c) sensor signal is out of range or d) incorrect/damaged input connection.
Gefran controller: The top display is showing Sbr. What does this mean?
This is usually an indication of a faulty thermocouple temperature sensor (open circuit or faulty cable).
Thank you for your enquiry below. Our heat tracing specialist will be in contact with you soon...
Good day. Please quote on heating wires for a freezer room (-30 deg.C)
Heating wires to...